Disclaimer of liability

1. Contents of online offer

The author assumes no liability for the currency, correctness, completeness or quality of the information provided. Any and all liability claims against the author regarding material or immaterial damage caused by the use or failure to use the information provided or by the use of incorrect or incomplete information, insofar as there is no demonstrable fault of an intentional or grossly negligent nature on the part of the author.
All offers are conditional and non-binding. The author expressly reserves the right to alter, amend and delete parts of the pages or the entire offer without separate notice, or to temporarily or permanently discontinue the publication.

2. References and Links

For direct or indirect references to third-party websites ("links") that lie outside the scope of responsibility of the author, liability would be assumed solely in such cases where the author has prior knowledge of the contents and it would be technically possible and reasonable for the author to prevent the use of illegal content.

The author herewith explicitly states that there was no evidence of illegal content on the linked pages at the time of creation of the link. The author has no influence on the current or future design, contents or authorship of the linked/referenced sites. The author therefore herewith explicitly dissociates from all contents of all linked/referenced pages that are altered after creation of the link. This disclaimer therefore applies to all links and references within our own Internet services as well as to third-party entries in the guest books, discussion forums, link directories and mailing lists created by the author and in all other forms of databases to which write access by third parties is possible. The provider of a referenced website is solely responsible for illegal, incorrect and incomplete contents, and especially for damages resulting from the use of or failure to use information presented in this way; the party that is only referencing the corresponding publication through links is not responsible.

News

NEW and coming soon

09/09/2021 DCAM Training Center, now equipped with a Mitsubishi MP2400 and MA2-100 rotary/swivel axis from ITS for scheduled…

Read more

Healthy Christmas

12/17/2020 We wish you a Merry Christmas and a happy, healthy and successful New Year.

Read more

ME Workshop with DCAMCUT

08/07/2019

Read more

Seminars

DCAMCUT Solo basic course

The five-day course “DCAMCUT Solo with EDMCAD (SolidWorks)” is recommended for users who are new to the DCAMCUT program. In case of prior knowledge of SolidWorks, the course only lasts four days.

Read more

Success story

Friedrich Erodierservice GmbH in the DCAM user report

Friedrich Erodierservice GmbH develops, plans and manufactures reliably with DCAMCUT

Read more