DCAMCUT Release Notes
The Wire EDM software that takes care of your business needs
Here you can find the latest updates and changes to DCAMCUT.
The screenshots seen in the notes are displayed in enlarged form on the right side of the page.
Known compatibility issues:
-
DCAMCUT SOLO is incompatible with the "HP Protect Tools". You have to uninstall these tools to run DCAMCUT SOLO without erors.
-
The integrated versions of DCAMCUT are not affected.- The DCAMCUT AddIn and the CAMWorks AddIn should not be loaded and used at the same time.
-
11/06/2023 Release Note 9.0.21171
Extension of the job functionality - Additionally: Optimize contour sequence, Grouping - Uniqua: Piece Common-Mode (Sequential transfer with…
-
10/09/2023 Release Note 9.0.21146
AGIEVISION V: Relocation of Threading Expert functionality from sequencing to borehole definition. Uniqua - dynamic programming new options wire…